Test conditions for machining centres - Geometric tests for machines with horizontal spindle (horizontal Z-axis) Ingestion-build-58863 These registers are in accordance

These registers are in accordance with ISO 19135

General guidance on the control of the generation of undesirable static electricity in solids

taking into account the behaviour of the a

address book

BS 7562-2 identifies basic site data which need to be acquired and analysed to enable the designer

Test conditions for machining centres - Geometric tests for machines with horizontal spindle (horizontal Z-axis) Ingestion-build-58863 These registers are in accordance1 Scope This part of ISO 10791 specifies, with reference to ISO 230 1, the geometric tests for machining centres (or other numerically controlled machines, where applicable) with horizontal spindle (i. e. horizontal Z axis). This part of ISO 10791 applies to machining centres having three numerically controlled linear axes (X axis up to 5 000 mm length, Y axis up to 3 200 mm length, and Z axis up to 2 000 mm length), but refers also to supplementary