Plastics piping systems. Polyolefin pipes and mechanical fitting assemblies. Test method for the resistance to end load (AREL test) has-corrigendum

Plastics piping systems. Polyolefin pipes and mechanical fitting assemblies. Test method for the resistance to end load (AREL test) has-corrigendum1 Scope This International Standard specifies a method to determine, for mechanically jointed polyolefin pipe and fitting assemblies in sizes of dn 63 mm, the effect of component relaxation and creep on the resistance of the assembly to pipe pull out under the long term application of a constant and longitudinally applied force. The susceptibility of the polyolefin pipe to stress crack failure initiated by the joint assembly is also examined. NOTE For

BS ISO 12123:2018 supersedes BS ISO 12123:2010

specification for cattle eartags contain:

Why should you use BS 6262‑4 - Glazing for buildings

This European Standard defines the method for determining the moisture content of a piece of sawn timber

Part 1: Injection vials made of glass tubing

Since its publication over 25 years ago

When introduced

designation and basic conventions for leader and reference lines

It has been updated to assist those engineers wishing to protect occupants from the hazards identified by risk assessments and also to evaluate existing premises to decide if they need to be upgraded to meet current requirements

PD CEN/TS 17249-3 on 112 eCall for coaches and buses is useful for:

and the choice of how many significant figures entered each calculation

To enable the comparison of the relative performance of filters so that the most appropriate filter can be selected