1-1/4" PVC Push Cap Compression Points Just slide it over the

Just slide it over the shaft of the bar approx

NOTE: An Idea is to use an old

This particular point is the Largest point that we sell

(1) Quick shaft

comes with 3

1-1/4" PVC Push Cap Compression Points Just slide it over theThe push cap is attached directly to the PVC pipe that is ready to be installed after all of the Bullet Mole shafts are removed. The push point is connected to the front or leading end of the pipe and the push cap is inserted into the bell housing on the opposite end of the same pipe, or If there is no bell housing then a coupling must be glued onto the pipe and the part inserted into the coupling. Once in place, the push cap may be struck with a