Indoor air - Detection and enumeration of moulds. Sampling by filtration shop-only

Indoor air - Detection and enumeration of moulds. Sampling by filtration shop-onlyBS ISO 16000 16: 2008 Indoor air. Detection and enumeration of moulds. Sampling by filtration BS ISO 16000 16 specifies requirements for long term (0,5 h to several hours) sampling of moulds in indoor air by filtration. Following the instructions given, a sample is obtained. This sample can then be used for subsequent detection of moulds by cultivation after suspension, according to BS ISO 16000 17, which is part of the complete measurement procedure.

This document is intended for application in a number of situations:

Architects of dwellings

This European Standard specifies requirements and gives recommendations on the design of potable water installations within buildings and for pipework outside buildings but within the premises

Some materials can be used at temperatures down to − 200 °C

Flexitank operators

BS EN 50483-2 applies to tensioning devices consisting of tension and suspension clamps designed to be used for installation of self-supporting ABC defined in HD 626

Measurement of temperature

EN AW-5049

Electron microscopy imaging and analysis methods

taking account of the potential for extensive damage and serious business interruption

BS EN 50171:2001 specifies the general requirements for central power supply systems for an independent energy supply to essential safety equipment

A revision of Table C