2 Inch Copper Push Point Compression Points If you are working with

If you are working with a different pipe

The tool can go further distances by just purchasing additional shafts

Pelican Case

the push cap may be struck with a hammer to drive the pipe past the obstruction and on to the other side

The digging hook can be attached to any digging bar that has a square

2 Inch Copper Push Point Compression Points If you are working withThis part is made of stainless steel and is used to insert a 2" "k" or "L" wall copper pipe into the ground after the initial hole is opened with the compression point. The point is inserted into the end of the copper pipe. There are 2 half pipe indicator lines cut into the point. Transfer the length of both lines, straight across and onto the copper pipe. ( Remove The point after marking the pipe). Drill a 3 8" hole through the sidewall of the pipe