Technical drawings. General principles of presentation - Sections on mechanical engineering drawings Ingestion-build-48348 Guidance for the development of

Guidance for the development of in vitro test methods is included in an informative annex to this document

dynamic strength implementing the maximum rated load for lanyards

— maintenance documentation describing the internal operation of systems software

— pre-cooling device

The service interface parameters

Technical drawings. General principles of presentation - Sections on mechanical engineering drawings Ingestion-build-48348 Guidance for the development of1 Scope This part of ISO 128 specifies general principles for presenting sections on mechanical engineering drawings following the orthographic projection methods specified in ISO 5456 2. For areas on sections, representation is according to ISO 128 50[1]. Attention has also been given to the requirements of reproduction, including microcopying in accordance with ISO 6428. NOTE The basic rules for cuts and sections are given in ISO 128 40[2].