1-1/4" PVC Push Point Compression Points This nozzle can be used

This nozzle can be used to moisten and remove soil from a smaller hole after a smaller compression point has been driven through the ground

It should be 5/8 of an inch long

3) The connector with the attached pipe or conduit is lowered into the exit pit and the opposite end is connected to the male thread of the shaft without having to turn either the pipe or the shafts

This is used to support the shafts and hold them up off of the ground while they are being driven in

The tool can go further distances by just purchasing additional shafts

1-1/4" PVC Push Point Compression Points This nozzle can be usedThis part is used to insert a 1 1 4" PVC Sch 40 pipe into the ground after the initial hole is opened with the compression point. The point is screwed into the PVC pipe and cuts threads on the inside of the pipe much like a tap. The Push Point will have the same as the outside diameter of the pipe itself. After the Push Point is attached the pipe then this assembly is shoved into the hole made by the compression point. As it proceeds, roots or